Question:

When I tried engraving is completely missing blade. All updates has been done, after that calibrations been done successfully. Is cutting keys well. No problem. But engraving doesn't. It does position procedures like always by probe. Than clamp is going fully right side and is try engraving missing blade completely. I used Xhorse XCCD30GL 2.5mm Engraving Cutter.

Notices:

Condor XC-Mini Plus II new version of Engraving function now is released.

Update new version and this function should work fine.

Complete!

Posted by: xhorsevvdi at 03:50 AM | No Comments | Add Comment
Post contains 91 words, total size 2 kb.