Question:

If a cutter breaks on Dolphin XP005 during cutting, or it runs out of battery in the middle of a cut, Machine seems to give errors when the probe doesn’t see an uncut key.

Is there any way to continue the key after changing the cutter?

Here Xhorsevvdi gives the

Solution:

Step 1

Put a new blank of the same type for the probe to detect.

Step 2

Once the identification is complete, click "Pause”.

Step 3

Remove the new blank, put the semi-cut key back in, and click "Continue”.

Step 4

Repeat process for the other side if needed.

Same way on other Xhorse Automatic Machineslike Dolphin XP005L, Condor XC-Mini Plus...

Hope this could help!

Posted by: xhorsevvdi at 10:19 AM | No Comments | Add Comment
Post contains 128 words, total size 3 kb.