Question:

The cutter/ probe gets stuck in the holder of Xhorse Dolphin XP005/ Xhorse XP005L/ Xhorse XP007 because

1)Clean cutter but dry tissue left inside

2)Probe gets broken

...

First, the only way to remove stuck parts is pulling them out, or replace the whole component.

Here are some

Possible Solutions:

1.Pliers

Make it go round, and pull it out by a pliers.

2.Remove the rough edges

Went rounds between removing rough edges, dry cloth, little wd40 on tissue, dry wipe again.

Done 4 or 5 times, and it moves in & out smoothly

Maintenance Tips:

1.Clean machine esp. remove metal filings by the brush inside the package

2.For machines that has been used for years, open it, clean inside parts, and lube ball screw and cross rail

Posted by: xhorsevvdi at 08:30 AM | No Comments | Add Comment
Post contains 140 words, total size 2 kb.