Question:

Xhorse Condor Mini Plus II Machine,No error it’s just make weird noise.

The it starts shaking.

Only the cutting side.

Feel like I have to tie it up from inside.

Here Xhorsevvdi tech shares the

Solution 1:

Tighten screws for fixing main axis.

1)Open Condor II Machine

For detailed steps:

remove the screw in the red cricle

Unplug the screen cable first
The cover can be removed by removing the corresponding screws on the outside.

Remove two or three screws on each side

2)After step 1, then tighten these screws

Usually the first suggestion will solve the problem.

But if this still not working, it is the spindle motor proble, you need contact your seller to get new part

Please do like the condor mini plus 2 repair guide to replace spindle part

https://www.xhorsevvdi.com/upload/pro/23111617001916069037.pdf

2.5.1 Replace the spindle motor and the cutter shaft
When the motor makes abnormal noise, it needs to be replaced. Refer the chapter 2.5.4 to remove the Z-axis screw shaft motor first, and remove the screws in the red frame below.

Then remove the spindle shaft to replace, insert the port according to the wire harness label

Posted by: xhorsevvdi at 07:13 AM | No Comments | Add Comment
Post contains 204 words, total size 6 kb.