This article is going to show you how to program 2018 VW T6 when all key lost using Xhorse VVDI2 Full Version.

Tools:

VVDI2 Key Programmer

VVDI PROG Programmer

Key Tool Max

Xhorse XKB501EN Wire Remote

 

Connect VVDI2 to vehicle.

Enter VW Menu.

Try auto detect type, NEC 24C64.

Select

4th immobilizer system - VW/ Skoda/ Seat>>Instrument with NEC+ 24C64 2014.06-

Try to read EEPROM.

Fail since we have to use a working key as required.

So we try to switch it to service mode for key programming.

 

Step 1.

Record ABS coding.

Step 2.

Remove dashboard.

Read EEPROM 24C64 using VVDI PROG.

Step 3.

Generate and write service dump

Back to VVDI2, click "Prepare service 24C64 EEPROM".

Load 24C64 eeprom file and save new dump file

Write service dump back to chip using VVDI PROG.

Restore dashboard.

Step 4.

Back to Xhorse VVDI2 homepage.

Step 5.

Load original dump file and write it back via OBDII.

Step 6.

Here we just go on smoothly without a working key.

Then with the dashboard being dark, follow prompts to reset it.

Read and save immo data.

Here Prepare Dealer Key will fail.

So select

Key Learn>>MQB platform instrument immobilizer>>Instrument with NEC+ 24C64 MQB key

Then click "Make Dealer Key" and put a normal dealer key into coil.

Click "Immo data prepare key" and load immo data file.

Step 7.

Select

Add key>>Learn key from immo data

Load immo data file and put chip close to ignition.

Success.

Step 8.

Reset Instrument.

 

Generate remote control using Key Tool Max and with XKB501EN Remote.

Learn remote control using VCDS.

Done!

http://blog.xhorsevvdi.com/xhorse-vvdi2-2018-vw-t6-akl-programming-guide/

Hide Comments | Add Comment