Question:

For the VVDI PROG EEPROM Read Clip which colour wire is for pin number 1 so I know correct location on the eeprom (chip) when I use VVDI Programmer.

Also what are the 2 free hanging wires used for as you can see them in the photo.

Here is the Answer:

PIN1>>Black wire, also a white dot is marked on PIN1.

2 free hanging GND wires are connected to the probe for some chips

Done! Hope this helps!

http://blog.xhorsevvdi.com/xhorse-vvdi-prog-eeprom-clip-using-tips/

Posted by: xhorsevvdi at 09:01 AM | No Comments | Add Comment
Post contains 87 words, total size 2 kb.